内蒙古11选五遗漏查询

How to build Voltage Inverter II



内蒙古11选五遗漏查询 This simple and inexpensive circuit can produce a dual (positive and negative) voltage from a single supply input. It is therefore extremely useful for powering opamp and other circuits that require a dual voltage from a single battery. The circuit will operate at an input voltage from around 5V to 20V and produce a output from +-2.5V to +-10V.

Circuit diagram

Parts
R1 1M Linear Pot
C1,C2 15uf 25V Electrolytic Capacitor
U1 LM380 Audio Amp Chip
内蒙古11选五遗漏查询 MISC Heatsink For U1, Binding Posts (For Input/Output), Wire, Board

Notes
1. U1 dissipates around 1W and will therefore require a heatsink.
内蒙古11选五遗漏查询 2. R1 is used to equalize the outputs. The first time you use the circuit, it should be set to mid range and then adjusted with the aid of a voltmeter. Measure each output while adjusting. The circuit is calibrated when both outputs read the same voltage (either positive or negative).


Author:
Email:
Website: http://www.aaroncake.net

Similar diagrams


Important!!!
We are not responsible for any injuries or damage caused by information from this website! Working with electricity is dangerous for your life, especially diagrams related to high voltage! We do not guarantee success in building devices using our diagrams! They are not tested by us. For questions about diagrams use author info below diagram or our contact page. Thank you!

凯利棋牌 闲来斗牛 全民湖南棋牌 开心飞鹰 老棋牌游戏